DESIGN SINTEZ
 Cabinets - Generated multielement units

Parameters and controls by default 

Page Elements
You can change the names of the generated element nomenclatures  in respective field (simply write in it the new name).
Sets the base (system) names of elements as current - Returns the names of the generated element nomenclatures by default as current
Sets the current names of elements in a mode by default - Sets the entered in the fields names  of generated element nomenclatures as parameters by default

Page Layers

You can change the names of layers  in respective field (simply write in it the new name).
Sets the names of layers in a mode by default - Sets the entered names of layers in fields by default. The option allows the operator to create intelligible (clear) for him layers.



 The program supports 2 ways for an insert of elements to the generated cabinet:
Entering of additional element nomenklatures -  The section allows an unitary manual entering of additional elements for the generated case particularly. They remain when you save the cabinet as temlate. After an exit from the module they are don't save.
Choice of additional element nomenclatures from the list - The buttons to the right from textual fields are buttons for a choice. They open Nomenclature elements for a choice of elements for addition. The added thus elements remain active after an exit  from the module.

The added additional elements are not shown on the screen. They take part in price formation only.


   In this page are specified distances of case elements for dimensioning. The dimensioning can be made  in relation to the centres of material completeness  for shelves, partitions, panels, floor and ceiling (if the option "Show distances on the centres for - SHELF BELOW - PARTITION AT LEFT - PANELS  INSIDE - CEILING DOWNWARDS and for a FLOOR BELOW" is active) or in relation to them bottom point. Not specified in the form distances of details are shown on the right of the drawing.

 Drawers
Back on a floor / Back behind a floor -  When the option is active back is on the floor. When it is switched off the design Back behind a floor  becomes active. 
Bottom between panels/ Bottom below - If the option is active, the drawer bottom is between its panels  and its size decreases with completeness of their material. When this flag is not marked, the bottom position is under its walls.

Save as unit

Option by default.  Specifies saving of the polyelement form as block (basic point - bottom front left).You must remove a mark if you want to use the generated cabinet for additional processing in the additional module to the program New Base and save it as other unit. Option Creates the element nomenclature is switched off automatically in this case

Distance of back from the external size in cm 

Parameter defines a position with a back on 4 countries, in conformity of external dimensions of a cabinet. Positive cost reduce the general size of a cabinet, and negative increase it. Parameter is set by default and defines a deviation of an element (back) at the generation of the nomenclature

EN Sintez Soft     Design Sintez     DS User  guide